adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- Calculation of Rolling Strain Velocity in Consideration of Adhesive Friction and Slide Friction
考虑粘着摩擦和滑动摩擦的轧制变形速度的计算 - The total adhesive friction coefficient is expressed as a combination of adhesive friction coefficients in elastic and plastic contact regime.
总的粘着摩擦系数被表示为弹性接触区与塑性接触区的粘着摩擦系数的组合。 - As adhesive, matrix resin accounted for a larger proportion in non-metallic and semi-metallic friction material. Its performance direct impacts on the using performance of friction material.
基体树脂作为粘接剂，在非金属、半金属摩擦材料中所占的比例较大，其性能的好坏直接影响摩擦材料的使用性能。 - Thermal shock cracking in friction surface, over heated and over burned microstructure in sub surface, adhesive element diffusion from surface to center occur due to friction heat. Layer delamination occurs also on the worn surface of the steel.
因摩擦热的影响，制动后钢的摩擦表面出现热震开裂，表层组织过热甚至过烧，表面的粘着物由表向里扩散； - Using friction coefficient tester, we have investigated the humility and UV-light dependence of the adhesive force and friction coefficient on glass surface and nano-TiO 2 film coated glass surfaces in the relative humidity of 30%~ 70%.
在30%～70%的相对湿度范围，使用摩擦系数测定仪，研究了玻璃表面和玻璃基体上纳米二氧化钛光致双亲性膜的摩擦系数与紫外光和环境湿度的变化规律。 - Results show that for certain fractal dimension, the total adhesive friction coefficient reduces sharply as the normalized contact area increases.
结果表明，对于一定的分形维数，总的粘着摩擦系数随归一接触面积的增大而急剧减小。 - This paper sets up a mathematical model for calculating thermal balance of plunger-cylinder wall friction pair in axial plunger pump, analyzes the cause of producing adhesive wear on the friction pair, and puts forward a way to solve the problem.
本文提出了轴向柱塞泵柱塞&缸孔摩擦副热平衡计算的数学模型，进而分析了这对摩擦副产生粘着磨损的原因，并提出了解决办法。 - The adhesive wear and abrasive wear were both existed in the wear mechanism of the composite material, the friction coefficient fluctuated with time changed.
复合材料的磨损机制是黏着磨损和磨料磨损交替进行，摩擦系数随时间的变化上下波动。 - We also find that, due to the water vapor condensation, the adhesive force and friction coefficient on sample surfaces increase first, then decrease with the relative humidity increase.
由于强的亲水性，样品表面的摩擦系数和黏附力随着湿度的增大先逐渐增大，然后急剧减小。 - Friction characteristics of PC and its alloys can be explained by adhesive friction theory, and wear of these materials are controlled by adhesive, abrasive and fatigue wear mechanisms.
聚合物及其合金的摩擦特性可由粘着摩擦理论解释，其磨损过程主要受粘着、磨粒和疲劳机理控制。